Epson C8230 Specifiche Scaricare il pdf (Pagina 13)

Note

• The printer will assume a setting of 1,200 BPS for

switch combinations other than those shown above.

• Since the maximum transmission speed (baud rate)

depends on your type of printer, refer to your

printer’s manual for details.

Jumpers

The jumper is a small terminal used for connecting or

disconnecting a circuit. The jumper is on when the

jumper plug covers both wires of the terminal. Jumper

settings can be changed by either attaching or removing

the rectangular jumper plug. If the jumper is to be

turned off, connect it to just one of the two terminal

pins as shown in the figure below. By doing this, you

can avoid losing the unused jumper plug.

Figure 2. Jumpers

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Nessun commento

Epson C8230 Specifiche Pagina 13