Epson Personal Document Station Informazioni Techniche

EPSON®Personal Document Station@Printed on recycled paper with at least 10% post-consumer content

8.Turn on the scanner by pressing the end of the powerswitch. The green Power light on the top right side of thescanner comes on. The Ready light also

The next screen asks you for the directory in which you wantto install the program files. Accept the default directory ordelete it and enter a new dir

10.If you selected not to install the File Management orPersonal Cabinet components in step 6, skip to step 11.Otherwise, you see the Visual Recall Se

Scanning DocumentsNow you are ready to start scanning using the built-indocument feeder. For instructions on using the attachablebusiness card guide,

3.Fan the edges of your document; then level the stack bytapping it on a flat surface.4.Hold the document with the side to be scanned facing downand g

After a few moments, the Xerox Scanning Interface dialogbox appears as the active window.Note:The Xerox Scanning Interface dialog box appears automati

10. Click Done. You see the Xerox Image Manager window.From the Image Manager, you can save your scanneddocument to a file, or print, fax, or e-mail t

Follow these steps to install the driver and print the READMEfile :1.Insert the EPSON PDS TWAIN Driver diskette in a diskettedrive.2.From the Windows

Call the EPSON Connection for the following:0Technical assistance with the installation, configuration,and operation of EPSON products0Assistance in l

A Note Concerning Responsible Use ofCopyrighted MaterialsLike photocopiers, scanners can be misused by improper copying of copyrighted material.Althou

IntroductionThis package contains everything you need for professionalquality document scanning and processing:EPSON® Personal Document Station™ (ES-3

This booklet tells you how to set up your scanner, install thesoftware, and scan a document. For additional instructions, seethe manual for the ES300G

Installing the Parallel lnterface CardFollow the steps in this section if you need to install thebidirectional parallel interface card in your compute

Carefully remove the interface board from its packaging,holding it only by its top edges. Then place it on a flat,clean surface.Caution:Avoid touching

Installing the CardFollow these steps to install the card in your computer:1.Turn off the computer and any peripheral devices.2.Disconnect the compute

Settng Up the ScannerFollow these steps to set up the scanner:1.Take the scanner out of its box and place it on a flat, stablesurface with the rear pa

6.Connect the scanner’s power cable to the power inlet on therear of the scanner and plug the other end into a groundedelectrical outlet.7.Turn the sc