Epson TWAIN PRO Network Guida di Configurazione Scaricare il pdf (Pagina 40)

Setting Up the Scanner

2-21

2. Connect the other end of the cable shown below to the USB

port on your computer, or USB hub.

Note:

❏ USBcablesenableyoutoconnectthescannerwhetheryour

computer is on or off. If you connect the scanner and turn it on while

your computer is on and the scanner software is not yet installed, a

dialog box or message promptingyou to set up the device may appear

on your screen. In this case, see the EPSON TWAIN Pro

installation instructions in Chapter 3 to complete the setup

procedure.

❏ Connect the USB cable to your computer before installing or

starting the scannersoftware. Do notconnectordisconnect the USB

cablewhilethescannersoftwareisopen.

❏ Make sure no other interface is used.

When changing the USB port in Windows 98

If you want to connect the scanner to a different USB port on your

computer or hub, you may need to remove your scanner from

your system first, depending on the version of Windows 98

installed on your computer. If Windows 98 Second Edition is

installed on your computer, you can change the USB port without

removing the scanner from the system. If your version of

Windows 98 is not the Second Edition, you need to remove and

then reinstall the scanner software in your computer as described

in “Changing the USB port” on page 2-22. For instructions on

checking your Windows 98 version, see the next section.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 116 117

Nessun commento

Epson TWAIN PRO Network Guida di Configurazione Pagina 40