Epson ESC Manuale Utente Scaricare il pdf (Pagina 20)

A-18

The default unit is 1/360 inch. The new position is measured in defined units from the

current top-margin position. Moving the print position below the bottom-margin

position moves the vertical print position to the top-margin position on the next page

ejects a cut sheet, if loaded.

The printer ignores this command if the command would move the print position more

than 179/360 inch in the negative direction or if the command would move the print

position in the negative direction after a graphics command is sent on the current line

or above the point where graphics have previously been printed.

ESC ( v

Sets relative vertical print position. (EPSON ESC/P2)

ASCII Code ESC ( v n

Hexadecimal Value 1B 28 76 n

Decimal Value 27 40 118

Range n

= 2

= 0

0 <

< 255

0 <

< 127

This command moves the vertical print position up or down from the current position,

as specified by the following formula

Vertical position = (d

x 256)+d

) x (defined unit) + (current position)

For positive (down) movement:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 287 288

Nessun commento

Epson ESC Manuale Utente Pagina 20